Podtec Bikepod Motorcycle Protective Storage System

The Podtec Bikepod is an indoor protective storage system developed to keep your cherished motorcycle in a clean and dry environment ensuring it is kept in the best possible condition. The Bikepod has been designed by motorcycle enthusiasts for motorcycle enthusiasts so you can be confident that only the best quality materials are used.

• Protects your bike from dust, moisture, rodents, and other contaminants
• Filtered fresh air in the pod prevents mould, mildew, and stale smells
• Constant running fan helps to dry out the bike which prevents rust and corrosion
• Easy to set up, simply unzip the top section, roll the bike onto the base, zip up the top section and plug in to inflate
• Seal-able cable opening to allow battery charger or other cables to pass through to the vehicle
• Premium quality PVC material ensures durability and also increases the clarity, so you get a better view of your bike while in the pod
• Cheap to run, only a few pence a day to keep your prized possession protected (see below on how to calculate the exact cost)
• Available in 2 sizes to suit a wide range of motorcycles

The Podtec Bikepod is designed for indoor use and is the ideal solution for cherished motorcyles which spend periods of time in storage. It comprises of two sections which are joined by a corrosion resistant nylon zip to form a dust and moisture tight seal. A sealable opening in the zip section provides an access point for cables to pass through which allows battery chargers etc to be connected to the bike. The base section is made from a robust, abrasion resistant 0.7mm PVC material and the top is made from high quality 0.35mm clear PVC which is thicker than most other brands. This thicker material is used to add durability but also to increase the clarity so the view of the bike inside is improved. An Integral filtered fan inflates the pod in minutes and runs constantly to ensure the pod is kept inflated and prevents stagnant air. The fan has a very low current draw so is incredibly cheap to run and has a long service life. The fan filters are washable which is ideal if the pod is used in a dusty environment.

The Bike pod fans have a very low current draw which makes them cheap to run. For example, the fan consumes just 0.48kWh of energy per day. You can calculate the exact daily running cost by multiplying 0.48 by the kWh cost from your electricity provider. As a guide the cost is less than 10 pence per day (correct as of August 2022).

The process of protecting your motorcycle with a Podtec Bike Pod is simple and can be achieved in under 10 minutes. Simply unfold the Bike Pod flat onto the garage floor, unzip the top section and fold back out of the way. Roll the bike onto the base and then pull the top section over. Zip the two sections together then plug in the fan to inflate (fan must be kept running to keep the Bikepod inflated). That’s all there is to it.

Podtec Bikepods are available in the following sizes:

• Size 1: 260cm x 75cm x 169cm
• Size 2: 300cm x 75cm x 169cm

Suitable for UK 3 pin 240v power supply and supplied with adaptors to suit other plug / voltage power supplies.

Podtec User Manual