Stack Pro Control Exhaust Gas Temperature Gauge

The Pro Control range from Stack offers so much more than a conventional gauge. They give the user total control and awareness of critical engine functions. By using Stack's precision stepper motor for needle movement and solid state sensors, accuracy is better than 2% with the reliability you would expect from a high quality product such as this.

• User configurable full dial colour change alarm warning
• Fast, smooth and accurate stepper motor needle drive
• Peak value tell tale memory
• Configurable back light colour with 7 different colour options
• 0-5V output for ECU or data loggers
• Outputs to cut fuel pump or ignition power in the event of oil pressure drop to prevent engine damage
• 52mm gauge diameter

Features of the Pro Control Exhaust Gas Temperature (EGT)gauge include:

Full Dial Alarm Warning - User configurable minimum and maximum EGT parameters can be set along with one of 7 different warning colours assigned to each parameter. For example, if a high EGT level is set at 800 Degrees C, then if the gauge reads above 800 degrees C the dial face changes to the colour you have selected to warn you. If the temperature increases further by 10 percent or more then the gauge flashes rapidly to further alert the driver. The same applies for low EGT.

Pro Control - The pro control feature activates low or high outputs whenever the user defined alarm level outputs are exceeded. For example when the high EGT alarm is activated the pro control output can be used to signal the ECU to increase fuelling or to switch any other electrical system.

Peak Recall - The peak recall function simply informs you of the highest and lowest EGT readings since the memory was last reset.

Configurable Back light - The LED back light has 7 user selectable colours for maximum visibility and readability. Colour options are white, red, yellow, green, blue, purple and turquoise.

The Stack professional exhaust gas temperature gauge is supplied with a wiring harness and a thermocouple sensor probe and adaptor with a 1/8" NPT male thread. Adaptors for other thread types are available to purchase separately.