Davies Craig EWP140 Electric Water Pump & Digital Controller Combo

This combo kit from Davies Craig offers a saving over buying the components separately.

EBP140 Alloy Pump

The EWP140 is the latest electric water pump from Davies Craig and has been designed as a high capacity upgrade for the original EWP80 pump. Constructed using a robust aluminium alloy body which is powder coated for a long lasting corrosion free finish. The inlet and outlet bolt to flanges on the pump and the kit is supplied with straight and 90 degree fittings to allow for multiple fitting orientations.

The EWP140 pump flows 140 litres per minute making it suitable for large capacity engines (3.5 to 5.0 litre) or high revving / high power output competition engines.

The benefits of fitting a Davies Craig EWP (Electric Water Pump) over an existing mechanical pump are -

• Coolant is circulated after engine shutdown preventing hotspots
• Increased engine power and torque
• Better control of engine temperature
• Increased cooling capacity
• Improved fuel economy
• Increased engine life
• Radiator size and coolant capacity can be reduced saving weight
• Increase in maximum engine speed

Digital Controller

This latest digital controller for cooling fans and Electric water pumps (EWP) is packed with features to ensure your cooling system stays at the optimum temperature.

An LCD display shows the current engine temperature and the required temperature (user settable). It also has symbols to indicate when either the cooling fans or pump are in operation. Audible alarms sound if the set temperature is exceeded by 10° C or if a temperature of 40° C is not reached within 5 mins of start up and also if the temperature exceeds 100° C.

When used in conjunction with a Davies Craig EWP this digital controller allows your engine to warm up quicker as it 'pulses' the pump until the engine is warm and then controls the pump speed to maintain the target engine temperature. The controller will also run the pump after engine shut down to eliminate hot spots (3 mins or until the temp is 10° C below the target temp).

The controller is factory set to 85° C but has 9 user settable temperatures ranging from 60 to 100° C. Simply set the temperature then let the controller do the rest.

The temperature probe can be mounted in the thermostat housing, top radiator hose or in the engine block close the coolant outlet.

Kit Contents:

1x EWP140 pump, 1x Digital controller, mounting bracket, wiring harness, 1x 90° flange adaptor for 38mm bore hose, 1x straight flange adaptor for 38mm bore hose, 2x O ring seals, 12x flange adaptor bolts, 1x in-line temperature sensor adaptor for 35mm bore hose, 1x 1/8" NPT blanking plug, 4x hose clips, instructions.