Stack Pro Control Fuel Pressure Gauge For Low Pressure Systems

The Pro Control range from Stack offers so much more than a conventional gauge. They give the user total control and awareness of critical engine functions. By using Stack's precision stepper motor for needle movement and solid state sensors, accuracy is better than 2% with the reliability you would expect from a high quality product such as this.

• User configurable full dial colour change alarm warning
• Fast, smooth and accurate stepper motor needle drive
• Peak value tell tale memory
• Configurable back light colour with 7 different colour options
• 0-5V output for ECU or data loggers
• Pro Control output powers an electrical circuit when a pre- set parameter its met, such as powering a 2nd fuel pump if pressure drops
• 52mm gauge diameter

Features of the Pro Control Fuel Pressure Gauge include:

Full Dial Alarm Warning - User configurable minimum and maximum fuel pressure parameters can be set along with one of 7 different warning colours assigned to each parameter. For example, if a low fuel pressure level is set at 2 bar, then if the gauge drops below 2 bar the dial face changes to the colour you have selected to warn you. If the pressure drops further by 10 percent or more then the gauge flashes rapidly to further alert the driver. The same applies for high fuel pressure.

Pro Control - The pro control feature activates low or high outputs whenever the user defined alarm level outputs are exceeded. For example when the low fuel pressure alarm is activated the pro control output can be used to activate a 2nd fuel pump.

Peak Recall - The peak recall function simply informs you of the highest and lowest fuel pressure readings since the memory was last reset.

Configurable Back light - The LED back light has 7 user selectable colours for maximum visibility and readability. Colour options are white, red, yellow, green, blue, purple and turquoise.

The Stack Pro Control fuel pressure gauge is supplied with a wiring harness and a solid state sender unit (part number ST262245) with a 1/8" NPT male thread. Gauges with a 0-1 Bar scale also include a 1/8" NPT female to M10 x 1 male adaptor. Adaptors for other thread types are available to purchase separately.